Setting The Control Logic (Ctrl.state) - Olimpia splendid SHERPA MONOBLOC S1 E 6 Mode D'emploi Et D'entretien

To navigate the "Function" or "Parameter" sub-menu,
use the following keys:
( ) Move back to the previous page
1
( ) Move on to the next page
2
( ) Go back to the higher level menu
3
( ) Go back to the main page
4
To access a function, click on the text of that
function.
NB: if the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
7.2.

Setting the control logic (Ctrl.state)

After accessing the "Ctrl.state" function, you can
choose whether to base the unit control logic on the
processed water temperature or on the ambient air
temperature (if the air probe accessory is installed
and correctly set). Select the required logic, then press
"OK" to confirm.
NOTES:
1. If the ambient air probe accessory is not installed (and correctly set), you can only choose "T-water
out".
2. If the relative function is activated (paragraph 8.3), the value of these parameters will be stored in the
memory and automatically reset after any possible voltage failure.
Function (1/4)
3
Ctrl. state: T water out
C l a valv : O
1
at a valv : Off
Solar setting: Without
Water tank: With
Parameter (1/1)
3
T HP max: 50°C
Cool run time: 5 min
1
Heat run time: 3 min
Ctrl. state
T water out
T room
OK
4
2
4
2
Cancel
25