Viewing The Status Of The Unit Parameters (Parameter) - Olimpia splendid SHERPA MONOBLOC S1 E 6 Mode D'emploi Et D'entretien

Thermostat
Other thermal
2-way valve
HP-Antifree
Gate-Ctrl
4-way valve
Disinfection
Flow switch
6.3.

Viewing the status of the unit parameters (Parameter)

These pages display the current values for the unit's operating parameters. After accessing the "Param-
eters" function, you can browse the various pages using the buttons on the left and right sides of the
window. The following table shows the information available.
NB: all information contained in this menu is "read only".
Label
T-outdoor
T-suction
T-discharge
T-Defrost
T-water in PE
T-water out PE
T-optional water sen.
T-tank ctrl.
T-economizer in
T-economizer out
Debug time
T-gas pipe
T-liquid pipe
T-auto mode
T-remote room
Dis. pressure
Indicates the current thermostat settings (paragraph 7.7)
Indicates the status of the additional heat source (paragraph 7.8)
Indicates the status of the 2-way valve on the system
Indicates the status of the anti-freeze protection
Indicates the status of the external contact (paragraph 7.15)
Indicates the status of the 4-way valve on the unit
Indicates the current status of the anti-legionella cycle (paragraph 4.10)
Meaning
Indicates the external air temperature detected by the unit
Indicates the temperature on the compressor inlet
Indicates the compressor delivery temperature
Indicates the temperature for the defrosting cycle
Indicates the temperature of the water entering the plate heat exchanger
Indicates the temperature of the water leaving the plate heat exchanger
Indicates the temperature of the water leaving the optional heater (paragraph 7.9)
Indicates the temperature detected in the water tank
Indicates the temperature on the economiser inlet
Indicates the temperature on the economiser outlet
Indicates the temperature detected on the gas side of the cooling circuit
Indicates the temperature detected on the liquid side of the cooling circuit
Indicates the current set-point temperature, calculated using the climatic curve
(paragraph 4.7)
Indicates the room temperature detected by the probe (paragraph 7.10)
Indicates the compressor delivery pressure value
Cool
Heat
On
On
On
Card in
Card out
On
Progess
Done
Error
On
23