Charging the battery in the bike:
•
•
•
14
•
•
•
•
i
66
216-03-1708 Gewijzigde herdruk Handleiding Innergy.indd 66-67
Comply with the above charging instructions.
P ark the bike solidly on its kickstand in the vicinity of a
power socket.
O pen the rubber cover cap of the battery charge plug, on
the rear left at the taillight, and put in the power plug of
the charger.
P ut down the charger securely and put the power plug in
the socket.
I f a LED light bulb in the taillight starts flickering, you
have properly connected the charger.
I f the battery is charged completely, the light bulbs in the
taillight will no longer be on and the light on the charger
will still be green.
I f you are finished charging, first remove the power plug
from the battery and put the cover cap back over the
charge plug. Then take the power plug from the charger
out of the socket.
Once or twice a year, ride around until the battery is
completely discharged. This is because completely
discharging and then recharging the battery has a
positive impact on its operational life.
Charging the battery separate from the bike:
•
Comply with the above charging instructions.
•
R emove the battery from the bike in accordance
with the previously given instructions.
•
P ut the battery on a flat, hard surface in the vicinity
of a power socket.
•
O pen the rubber cover cap of the battery charge
plug, on the rear left at the taillight, and put in the
power plug of the charger. (Photo 15)
•
M ake sure that the power plug sits firmly in the
battery. (Photo 16)
•
Put the power plug in the socket.
•
I f an LED light bulb in the taillight starts flickering,
you have properly connected the charger.
The flashing LED indicates the condition of the
battery. The LED starts on the far right side and
moves to the right. LED indicates a condition that
is approximately 20% charged. When the flashing
LED is at the far right, this means that the battery
is fully charged. On the charger itself a green light
will be on, indicating that the charger is in use.
(Photo 17)
•
I f you are finished charging, first remove the power
plug from the battery and put the cover cap back
over the charge plug. Then take the power plug from
the charger out of the socket.
15
16
17
67
05-08-2008 12:00:36