For The Installer/Electrician Removing The Transit Fitting; Screw Feet - Miele professional WS 5080 Mode D'emploi

Installation
This machine should not be used for articles
which have been treated with dangerous or in-
flammable substances.
To avoid the possibility of frost damage on no
account install the machine in a room which is
exposed to frost.
When the machine has been installed in its fi-
nal position, only then remove the red transit
fittings marked "A" and "B".
To remove them detach the front and the rear
panel.
M.-Nr. 04 506 754
A
"A" (2 pieces)
B
"B" (2 pieces)
The screw feet may be adjusted to compen-
sate for any unevenness in the floor surface.
The base frame should not be resting on the
floor. If installed on a plinth the machine must
be secured to the plinth and the plinth bolted
to the floor (see enclosed installation dia-
gram). Bolts are provided with the machine.
Electric heated washer extractors installed
without plinth, with their feet directly on the
floor do not need to be secured.
Do not install the machine on carpeted floor-
ing if the carpet pile blocks the ventilation gap
at the base of the machine.
57