Spin Times; Short Programme; Starching; Skip Programme Stage - Miele professional WS 5080 Mode D'emploi

Notes

Spin times

After the last rinse, and if the "without spin"
button has not been activated
Programme:
A
B C D
, and
F
E
and
If the load is unevenly balanced in the drum
the spin will be interrupted. Run-up to spin re-
sumes automatically once the imbalance has
been redressed.
Note: The "Separate spin" setting can be used
for textiles that have been handwashed
and can be spun.

Short programme

This programme is intended for dealing with
lightly soiled laundry only. Reduce the amo-
unt of detergent according to the load reducti-
on. The programme consists of a main wash
(wash temperature 40°C - this can be repro-
grammed to 50°C or 60°C), 2 rinses and a fi-
nal spin.

Starching

Starching can take place in the Cottons pro-
grammes and in the Short programme.
After selecting the programme press in the
"Starch" button.
When the programme gets to the "Starch" po-
sition it pauses, the "Starch" indicator light will
illuminate.
46
= 7 minutes
= 1 minute
= 7 minutes
Press and release the "Starch" button to conti-
nue the programme adding starch to water as
it flows into compartment (I) according to ma-
nufacturer's instructions.
Skip a programme stage
If a programme stage is to be skipped turn the
programme selector switch to the "End r"
position. The programme sequence lights
flash down through the stages. Reselect the
programme when the appropriate stage is lit
up. The programme then continues.
Programme cancellation during peak load
cut-out
If the heater elements are shut down for lon-
ger than 45 minutes the programme is cancel-
led. A programme cancellation is indicated
by the display of the error message "Heating"
(the "Main wash" indicator light flashes).
Press and release the "On-Off" button (the
"Main wash" indicator light will go out). Press
the "Start" button to re-start the programme.
M.-Nr. 04 506 754