Abus TVHD75500 Manuel Utilisateur page 36

6. As the port interface, select the appropriate COM interface.
7. Settings for the interface: Enter the baud rate used by your camera.
You do not need to change the other settings.
8. Click Save and Apply to apply the changes.
You can then control the high-speed motorised dome with the VMS software.
To access the configuration menu of your camera, select the preset 95. Alternatively, you can select
the Tour item on the LCD display and then select the configuration menu there.
You are in the configuration menu of the camera and can use the arrow keys to navigate the menu.
7. Key combinations
This high-speed motorised dome supports three control protocols: Pelco D, Pelco P.
These protocols are supported by many recorders (such as HDVR 3.0 / TVVR411x0) and
controllers, allowing them to control the high-speed motorised dome.
The factory setting of the camera is Pelco D/P (automatic detection) with 2400 bps (bits per
second) set. The following information explains how to control the camera using the control
panel TVAC26000. Operation with other control units that use the Pelco D/P protocol is
possible, but the keys may have different names.
Preset
33
34
35
36
37
38
39
40
41
42
43
44
92
93
94
95
96
Function
Auto Flip
Pan Zero
Tour 1
Tour 2
Tour 3
Tour 4
IR cut filter On
IR cut filter Off
Pattern 1
Pattern 2
Pattern 3
Pattern 4
Turn on the limit
settings
Set the limit settings
Restart
OSD menu
Stop scan
97 Start random scan
98 Start image scan
99 Start pan scan
100 Start tilt scan
101 Start panorama scan
102 Tour 5
103 Tour 6
104 Tour 7
105 Tour 8
36