Meec tools 011625 Mode D'emploi page 24

EN
Check the grease level before use and refill
when necessary.
10. Run the hammer drill warm, if necessary,
and check the grease level. Fill with
grease if no grease can be seen when the
hammer drill is held upright.
11. To fill grease, remove the grease cap with
the supplied spanner. Be careful not to
damage the seal under the cap.
12. Always check the grease level before use.
13. Replace the cap after refilling.
FIG. 8
REGULAR CHECKS
• Always replace, or resharpen blunt bits.
Blunt bits overload the motor and are less
effective.
• Check at regular intervals that all screw
unions on the hammer drill are properly
tightened. Retighten if necessary, otherwise
there is a risk of serious personal injury.
• Protect the motor windings from damage,
oil and water.
24