Publicité
Les langues disponibles
Les langues disponibles
when working in areas where the drill can
come into contact with concealed
electrical cables or its own power cord.
If the drill comes into contact with a live
wire, unprotected metal parts on the tool
can give the user an electric shock.
USING AND LOOKING AFTER
POWER TOOLS
•
Do not force the power tool. Use the
correct power tool for the planned work.
The correct power tool will work better
and more safely when used with the load
for which it was designed.
•
Do not use the tool if it cannot be
switched on and off with the power
switch. Power tools that cannot be
controlled with the power switch are
dangerous and must be repaired.
•
Unplug the plug from the mains and/or
remove the battery from the power tool
before making any adjustments, replacing
accessories or putting the tool away.
These safety precautions reduce the risk of
accidently starting the power tool.
•
Store power tools out of the reach of
children when not in use. Never allow
anyone who is unfamiliar with the power
tool and these instructions to use the tool.
•
Power tools are dangerous in the hands of
inexperienced users.
•
Keep the power tool properly maintained.
Check that moving parts are not
misaligned, jammed or loose, and that
there are no other factors that could affect
the safe use of the tool. If the power tool
is damaged, it must be repaired before
being used again. Many accidents are
caused by poorly maintained power tools.
•
Make sure that cutting tools are sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less likely to
jam and are easier to control.
SERVICE
Make sure that the power tool is serviced by
qualified technicians that only use identical
spare parts. This will ensure that the power tool
remains safe to use.
HAMMER SAFETY WARNINGS
•
Wear ear protectors. Exposure to noise
can cause hearing loss.
•
Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
•
Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
REDUCTION OF NOISE AND
VIBRATIONS
•
Plan the work so that exposure to heavy
vibrations is spread over a longer period.
•
To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
•
Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
–
Only use the tool in accordance with
these instructions.
–
Check that the tool is in good condition.
–
Use accessories in good condition, and
which are suitable for the purpose.
–
Keep a firm grip on the handles/grips.
–
Maintain and lubricate the tool in
accordance with these instructions.
SYMBOLS
Read the instructions.
Safety class II.
EN
21
Publicité
