Publicité
Les langues disponibles
Les langues disponibles
SUPPORT HANDLE
The support handle can be placed on either
side, which makes it easy to handle the
hammer drill in different positions. Screw
on the support handle clockwise and firmly
tighten. Remove the support handle by turning
it anticlockwise.
FIG. 2
NOTE:
Always use the support handle and hold the
hammer drill firmly with both hands.
SETTINGS
Percussion function only
FIG. 3
Percussion drill function
FIG. 4
Spindle lock
FIG. 5
DRILL
•
The drill is not centred when the hammer
drill is run with no load. This does not
affect the precision of the drill hole, in
that the drill is automatically centred
when drilling.
•
The chuck is maintenance-free. The dust
protector prevents dust penetrating the
hammer drill when in use.
Assembly and dismantling
Clean and lightly lubricate the shank of the drill
(1). Put the drill in the chuck (2) by twisting it
(3) until it locks in place. The drill shank locks
automatically. Pull on the drill to check that it
is properly in place. Pull back the chuck sleeve
and take out the drill.
FIG. 6
HOW TO USE
NOTE:
When starting the product there may be a
temporary voltage drop in the mains supply,
which could affect other equipment. Such
interference does not normally occur if the
impedance in the mains supply Zmax is less
than 0.195 ohm. Contact your electricity
supplier for more information.
7.
Plug the plug into an earthed power point
with the correct mains voltage. The plug
is correctly plugged in and the hammer
drill is ready to use when the status light
(1) goes on. Press the power switch (2) to
start the hammer drill.
FIG. 7
8.
Place the tip of the drill against the
surface and start the hammer drill. In
some situations the tip of the drill must
be pressed hard against the surface to
activate the percussion action. This is not
a malfunction, it is caused by the safety
mechanism to prevent impact when there
is no load.
9.
Hold the hammer drill firmly in both
hands and use the weight of the tool to
counteract the recoil. Do not press too
hard, this will reduce its performance.
IMPORTANT:
At low temperatures the viscosity of the
grease can prevent the activation of the
percussion function even though the motor is
running. In which case, run the hammer drill
for five minutes with no load to warm up the
grease.
MAINTENANCE
REFILLING GREASE
WARNING!
Switch off the hammer drill and pull out the
plug before refilling with grease. Th reservoir
holds enough grease for about 60–80 hours
of work.
EN
23
Publicité
