Publicité
Les langues disponibles
Les langues disponibles
EN
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage
Rated output
Torque
Stroke rate
Percussion force
Chuck
Tool holder
Drilling capacity
Weight
Cord length
Sound pressure
level, LpA
Sound power
level, LwA
Vibration level*
Vibration level**
* ah, HD = percussion drilling in concrete
** ah, CHeq = chiselling
Always wear ear protection.
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance
with EN 60745-2-6:2010.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
22
230 V ~ 50 Hz
1600 W
58 Nm
3800 rpm
Ø 48 mm
SDS-Max
Metal: 30 mm
Concrete: 40 mm
7.3 kg
2 m
93.9 dB(A), K = 3 dB(A))
104.9 dB(A), K = 3 dB(A)
13550 m/s², K = 1.5 m/s²
12299 m/s², K = 1.5 m/s²
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Powerful machine with two function modes
for stripping concrete and metal. Hammer
drill mode, chisel with free rotation and chisel
with rotation stop. SDS-Max holder for quick
and tool-free changing of drills or chisels.
9 J
The handle is vibration damping and has soft
grips for optimum control. A safety switch is
activated if the tool fastens. Supplied with the
following accessories: Pointed chisel (18x320
mm) Flat chisel (18x320 mm) Three drills
(16/18/22x320 mm)
1.
SDS-MAX quick chuck
2.
Safety clutch
3.
Power switch
4.
Status light
5.
Support handle
6.
Gear housing
FIG. 1
USE
BEFORE USE
•
Check that the mains voltage corresponds
to the rated voltage on the type plate.
•
The plug must be plugged into a correctly
installed and earthed power point.
•
Check that the power switch is switched
off. If the plug is plugged in when the
power switch is in the ON position the
hammer drill will start to move, which can
cause serious personal injury.
•
An extension cord must have a cross-
sectional wire area to match the power
supply to the hammer drill. Do not use
longer than necessary extension cords.
Publicité
