Size Switching; Input Signal Screen Display - Hitachi CMP420V1 Manuel Utilisateur

OPERATING INSTRUCTIONS (continued)

Size Switching

Each time the SIZE button of the remote control or the monitor is pressed, the screen display area will change in
sequence and the status will be displayed at the bottom of the screen.
* Real mode gives the image of the same shape as it is displayed on a computer monitor.
This mode is only available for VGA (640 X 480) and WVGA (864 X 480).
Display area selection diagram (RGB input)
Resolution Full display
Display
640 X 480
(VGA)
800 X 600
(SVGA)
1024 X 768
(XGA)
1280 X 1024
(SXGA)
1600 X 1200
(UXGA)
Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that
flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On
the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the monitor.
• The display will go out in approximately 6 seconds.
RGB
Off-timer
On-timer
RECALL button
SIZE button
Real
Full Normal
-- -- Min.
OFF
-- -- : -- --
SIZE button
Normal Full Zoom1
*
Zoom3 Zoom2
Circular display
Real Zoom1
* VGA and W-VGA
only
RGB2
RGB
H : 48.4kHz
V : 60.1 Hz
RGB 1 RGB 2 MUTE VOL
AV1 AV2 AV3 AV4
AUTO PinP SIZE RECALL
MENU
OK
ID ID SET
Zoom2
Input mode
Signal mode
Input horizontal frequency
Input vertical frequency
RECALL button
Zoom3
can reduce