Installation Instructions; Installation; Anti-Tumble Measures - Hitachi CMP420V1 Manuel Utilisateur

INSTALLATION INSTRUCTIONS

Installation

• If you have purchased the model without the stand attached:
When installing the monitor, use the optional Desk-top Stand (CMPAD05B,05).
The Desk-top Stand has been used for the illustrations in this manual.
WARNING
Use one of the special mount units to install this product. A mount of insufficient strength or inadequate design can cause overturning or
dropping and result in fire, electrical shock or injury. Please note that our company assumes absolutely no responsibility for personal injuries
or property damage caused by use of other mount units or improper installation.
CAUTION
• Installation of the wall mount unit and ceiling mount unit can be dangerous, so do not attempt this work
yourself. Ask your dealer to provide the name of a qualified installer.
• In order to prevent an internal temperature increase, maintain a space of 10cm (4 inches : For a desktop set-
up) or more between the sides and other objects such as walls, etc., so that the ventilation holes are not
blocked.( ✻ )

Anti-tumble measures

CAUTION
Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury.
Securing to a wall or pillar
Using a commercially available cord, chain and clamp, secure the set to a firm wall or pillar.
Securing desktop
1) Using wood screws (two), fasten the set to the clamping screw holes on the rear of the stand as shown.
2) Using commercially available wood screws, secure the set firmly in position.
10cm (4 inches) or more
Clamp
Cord
chain
Hook
Chain
cord or chain
clamp
Wood screw
Two places
*
or
Wall or Pillar