Connecting To A Pc - Hitachi CMP420V1 Manuel Utilisateur

INSTALLATION INSTRUCTIONS (continued)
Read SAFETY INSTRUCTIONS (
proceeding to these steps:
• Choose an appropriate site and install the product on a level table where the stand is secure.
• Install the monitor to have ready access to a power socket available.
• Make sure that the power switch of this device is turned off.

Connecting to a PC

(1) Make sure that the display signal of the personal computer to be used is compatible with the specifications of this
device.
• See "Product Specifications" concerning the specifications of this device.
(2) Make sure that the power switch of the personal computer is turned off.
(3) Connect the signal input terminal (RGB 1 or RGB 2) on the rear panel of this device to the display signal output
terminal of the personal computer.
• Use a cable that fits the input terminal of this device and the output terminal of the personal computer.
• Depending on the type of personal computer being connected, the use of an optional conversion adapter or the adapter provided with
the personal computer may be necessary in some cases. For details, refer to the instruction manual of the personal computer or ask the
personal computer manufacturer or your local retail dealer.
Speaker (R)
to
Monitor rear panel
Power cable
connector
Power
(DVI) (D-sub)
cord
To signal To signal
output output
terminal terminal
) carefully to ensure maximum safety before
PC
Speaker (L)
3.5mm
Stereo
mini jack
To audio
output
terminal