Publicité
Les langues disponibles
Les langues disponibles
plug with an earth pin. The plug must
only be used with an appropriate wall
socket,
installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
correct. Do not modify the plug
supplied with the equipment, if it does
not fit the wall socket then get an
electrician
to
socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig. A.
Make sure that the appliance is only
connected to a wall socket with the
same pin layout as the plug. Do not
use an adaptor with this appliance.
Always
observe
recommendations
electrical appliances:
1
Make sure that the mains supply
voltage matches that of the machine
before plugging it in.
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match
the pins for plug on the machine. Do
not use any type of adapter.
2 To reduce the risk of electrical
shock,
always
correctly
install
an
electrical
the
following
when
The supply
unplug
the
immediately after use and before
proceeding to clean it.
and
3 Only plug the machine into suitably
earthed wall sockets, as shown in Fig.
A. An inadequate electrical connection
may result in electrical shocks. If the
plug is not suitable for the wall socket
then change it for one that matches,
bearing in mind that the earth wire
must always be connected. If in doubt,
call BH technical services.
4 Never leave the unit unattended when
it is plugged in. Unplug it after use.
5 Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6
Never
recommended by the manufacturer.
7 Do not use the machine if the mains
cable becomes damaged or worn.
8 Keep the mains cable away from hot
surfaces.
9 Do not use the machine outdoors.
using
10 To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor, as shown in Fig.0.
The assistance of a second person is
recommended for the assembly stage.
Make sure that all of the pieces are
present:
(1) Glass base; (2) Central post; (5)
unit
Bottom retaining washer central post;
11
use
accessories
not
Publicité
