Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DAILy CLEANING
For cleaning: Switch off the SINA appliance. Wait until the SINA appliance has
cooled to hand temperature before starting to clean.
please note:
Do not use steel wool or sharp objects.
Your induction cooking appliance is not splash-water resistant. Therefore, do
not use running water or steam to clean it.
To remove dirt and deposits on side walls, you can use standard pH-neutral
cleaning products based on non-ionic and anionic tensides and mild organic
solvents such as alcohol and glycols.
Finally, remove all cleaning product residue, wipe down the cleaned surfaces
with water, and rub dry with a dry cloth.
WEEKLy CLEANING
In addition to daily cleaning, the air filter
firstly to ensure a sufficient supply of cooling air and secondly to prevent the
filters' effectiveness for grease and other vapours from being impaired.
To do this:
Remove the filter from below the air inlet.
Clean the filter in a dishwasher or with hot water and soap.
Refit the filter correctly before using your SINA appliance again.
Important: A dirty filter may cause overheating, resulting in a drop in
performance and damage to the SINA appliance! A missing filter may allow
dirt to accumulate, resulting in a drop in performance and damage to the
SINA appliance!
24
must be cleaned once a week,
5

5. TroUBLEShooTING

The SINA appliance may only be opened by trained and approved service
specialists. Do not touch any parts inside the appliance. If you notice that the
cooking surface is damaged, you must switch the SINA appliance off and
disconnect it from the mains supply.
INDUCTIoN hoBS & WoK
The most common problems
Fault
Cause
No heat,
No power supply
LED does not flash
Power line fuse tripped
Appliance not switched on
Appliance defect
No heat,
Pan is not detected
LED flashing
List of possible display codes
Fault
Cause
E01
E02
Overvoltage
E03
E10
System temperature too high
E11
Pan temperature
too high
E12
E13
Appliance fault
E14
E15
Residual heat indicator
Glass ceramic hotter than 50 °C
remedy
Plug the appliance in,
check the plug connection
Check and reset the fuse
Switch on appliance
Contact customer service
Pan too small or not
induction-friendly
remedy
Replace pan,
otherwise
Contact customer service
Reduce power
Remove pan
Reduce power
Contact customer service
Not a fault – serves
to warn user
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sina twinSina wok

Table des Matières