Introduction; Initial Start-Up - Menu System SiNA One Mode D'emploi

1. INTroDUCTIoN

DEAr CUSToMEr
S NA
Congratulations on your purchase of a SINA
induction appliance!
The following pages contain important information
Standalone Induction Appliance
and advice about your SINA induction appliance. They
explain how to start it up, operate it and care for it
properly. Where necessary, attention is drawn to the
differences between specific models.
Please read these operating instructions carefully
before using your SINA appliance for the first time.
Then store them in a secure place so that you can
refer to them quickly if required.
We accept no liability for damage caused by failure to
comply with these instructions or incorrect actions
being taken.
If you encounter a problem which is not described in
these operating instructions, you are unsure about
anything, or faults occur that you cannot remedy
yourself, please contact your service partner, or
alternatively please contact us directly.
MENU SYSTEM AG
Subject to technical modifications at any time and without prior
notice.
MENU SYSTEM AG Item no.: 200574 | V 1.0
Oberstrasse 222
CH-9014 St.Gallen Copyright
info@menusystem.ch Copying and translation are only permitted with the written permission
www.menusystem.ch of the manufacturer, MENU SYSTEM AG.
18
. These operating instructions are copyright-protected.
©

2. INITIAL STArT-Up

Your SINA appliance may only be installed and started up in accordance with the
applicable safety regulations in your country.
Remove all remaining packaging and check your SINA appliance for external
damage. Do not start up the appliance if there are any signs of damage. To make
it easier to transport your SINA appliance in the future, please keep hold of the
original packaging.
Your SINA appliance must be placed on a flat surface. This surface must be
capable of supporting a weight of at least 50 kg. The rotary switch must be readily
accessible. Do not cover the air inlet area on the front of the appliance. The air
inlet temperature must be lower than 40 °C. There must be a gap of at least 5 cm
between the rear of the appliance (air outlet area) and the wall or the closest
object.
Check the mains voltage and make sure that it matches the voltage specified on
the rating plate of your SINA induction appliance. Please ensure that your SINA
appliance is positioned correctly and that it does not wobble, and make sure that
all rotary switches are in the off position (red line aligned with status indicator).
Connect your SINA appliance to the mains supply by plugging it in.
If your SINA model does not have a pre-fitted plug, if you intend to change the
plug or if you want to connect the SINA appliance directly to the mains supply, the
electrical installation work must be carried out in accordance with the specific
national and local regulations by an approved electrical installation firm. It is
absolutely essential to heed the information on the rating plate, the warning
symbols and the safety regulations.
Remove all objects from the cooking surface of the SINA appliance before using it
for the first time.
Now you are free to enjoy stunning induction technology in the form of your
SINA induction appliance.
19