Velleman VL1237 Notice D'emploi page 6

• Insert the batteries in the charger. When charging only 2
batteries, these batteries must be inserted in the 2 slots on the
left.
Only charge 2 or 4 batteries simultaneously, the charger
will not work with 1 or 3 batteries inserted.
Only charge batteries of the same type with the same
capacity simultaneously.
Do not attempt to charge non-rechargeable batteries!
• After inserting the batteries, fast charging mode starts. An indication
of the expected charging times is given in table 1 on page 3 of this
manual.
• During charging, the status LED [A] will be red.
• When batteries are fully charged, the status LED [A] turns
green.
• When batteries are full or the predetermined charging time (6h)
expires, the charger goes in maintenance mode. A small current
maintains the voltage level of the batteries (see table 2 on page
3).
• To discharge the batteries, press on the discharge button [B].
The status LED [A] turns yellow during discharge mode.
Pressing again on the discharge button [B] will interrupt the
discharge process and continue the normal charging of the
batteries.
• When batteries are completely discharged, the status LED [A]
will turn red and the fast charge process start.
• When batteries are full or the charger is not in use, disconnect
the charger from the mains or car cigar plug. Remove the
batteries from the charger.
• To remove the adapter plug, press on the lock-button on the
back of the unit and slide the plug away from the adapter (refer
to the picture on page 2).
00 (22/10/2008)
VL1237
6
®
Velleman