Maintenance - Renkforce BT-RSD1802K Notice D'emploi

Operation
Caller ID display
• For an incoming phone call, the caller ID is shown in the display.

If the caller suppresses his caller ID or the mobile phone network does not support this feature, the caller
ID cannot be displayed.
Audio streaming
Audio streaming is the transmission of audio data (music) by Bluetooth® to the SD tuner.
If you have am A2DP-capable Bluetooth®-device, you may connect it to the SD tuner by pairing as described above
and establish an audio transmission.
• Ensure that the two devices are connected by pairing.
• Start playback/auto transmission at your Bluetooth® device (see corresponding operating instructions).
• Push the button MODE / PAIR (19) until BT AUDIO is shown in the display.
• The audio transmission is now active.
• You may now remote-control playback of your Bluetooth® device with the buttons  (8) and  (1) and
button PAU (12) as usual.

Maintenance

Regularly check the technical safety of the SD tuner, e.g. for damage of the cables or the casing.
If it can be assumed that safe operation is no longer possible, the device must be turned off and precautions are to
be taken to ensure that it is not used unintentionally. Disconnect the car power system!
It can be assumed that safe operation is no longer possible if:
• the device is visibly damaged
• if the device does not function for some reason, or
• following considerable stress during transportation
76

Operating Instructions
English