Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SLBU/SLMU
Attach SLBU/SLMU to RPA or RPM
1.
On SLBU, partially install four thumb nuts (D) to SLBU main
plate screws. Be sure to install thumb nuts with tapered side
down. (See Figure 8)
NOTE:
If using optional security brackets (C) to connect SLBU
bracket to RPA or non-locking RPM mount, refer to
Security Bracket Installation section prior to installing
thumb nuts.
Install thumb nuts
with tapered
side down
1
(D) x 4
(A)
Figure 8
2.
Attach SLBU/SLMU to RPA/RPM. Refer to RPA/RPM
installation manual for details.
Security Screw Installation (Optional)
1.
Install #8-32 x 3/8" button head security screws (K) into
security holes on SLBU/SLMU legs. (See Figure 9)
NOTE:
Up to two security screws can be installed on each leg.
It is recommended that screws be installed in holes that
are difficult to access to achieve maximum security.
NOTE:
Cable ties (not included) may be used instead of the
security screws. Thread cable tie through both holes on
leg and secure cable tie.
8
1
(B)
security hole
Figure 9
Security Bracket Installation (Optional)
NOTE:
Security brackets (C) can only be used when
connecting SLBU bracket to RPA or non-locking RPM
mounts.
1.
Install security brackets (C) over screws on SLBU main
plate. (See Figure 10)
2.
Partially install thumb nuts (D) onto SLBU main plate
screws. (See Figure 10)
Figure 10
Installation Instructions
(K)
(D) x 4
2
(C) x 2
Publicité
Table des Matières
