Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
4.
Place SLBU/SLMU legs (B) over screw adapters and
height-adjustment nuts. (See Figure 4)
NOTE:
Make sure arm latch clips are in the unlocked position.
(B) x 3 or 4
Figure 4
5.
Press locking buttons on SLBU/SLMU leg (B) firmly and
simultaneously push clip cover away from enclosed sliding
stud mount bracket until clip cover is in the locked position.
(See Figure 5)
6.
Repeat Step 5 for remaining legs.
WARNING:
Make sure legs have securely locked onto
height-adjustable nuts with the latch clips. If the legs are not
properly locked onto the adapters, the projector could fall
from the SLBU/SLMU mount causing SERIOUS INJURY or
DEATH!
5
locking buttons
open position
Figure 5
locked position
7.
Manuever legs so that sliding stud mount brackets and
screws are towards the middle of the projector.
Figure 6) and (See Figure 7)
8.
Position sliding stud mount brackets and screws so that
SLBU or SLMU main plate (A) can be evenly mounted to
legs. (See Figure 6) and (See Figure 7)
9.
Use 1/4" hex key (U) to secure Allen nuts (T) to screws on
sliding stud mounts. (See Figure 6) and (See Figure 7)
NOTE:
The following examples are two of many possible
scenarios based on typical examples of mounting hole
patterns. Specific connection points will vary based on
the hole pattern. Multiple scenarios may be used for
each specific hole pattern as long as the weight of the
projector is centered and balanced after mounting.
Three-hole scenario example
(A)
sliding stud mount
brackets and
screws
Four-hole scenario example
(A)
sliding stud mount
brackets and
screws
SLBU/SLMU
(T) x 3
9
Figure 6
9
Figure 7
(See
(T) x 4
7
Publicité
Table des Matières
