Re-Pressing; Cleaning, Maintenance And Repair (Fig. 13, 14, 15) - NovoPress ACO401 Manuel D'utilisation

ACO401
8

Re-pressing

EN
Re-pressing is always necessary if a pressing operation has not been fully completed. Check
the system supplier's instructions to ascertain whether re-pressing is permitted. If it is permitted,
please note the following differences from the initial pressing operation that must be complied
with.
9

Cleaning, maintenance and repair (Fig. 13, 14, 15)

Service intervals
Novopress recommends that authorised NOVOPRESS specialist workshops be used for
maintenance and repair work (see service addresses).
Only have the device and the press tool repaired by a specialist.
WARNING!
Risk of injury from breaking claws on the adaptor jaw and damaged pins
on the press collar
Holding the press device incorrectly and changing its position before and during re-
pressing means that the claws can no longer grip the pins properly.
The tips of the claws may press directly on the pins, causing the claws and pins to
break and fragments to fly off.
Therefore
– After positioning on the press collar, press the jaw levers on the adaptor jaw
together as far as possible using the grip. (Fig. 12)
– Make sure that the claws of the adaptor jaw always grip the press collar pins
throughout the re-pressing operation. (Fig. 11)
CAUTION!
Risk of injury when cleaning or carrying out maintenance work due to
pressing the on switch unintentionally.
Therefore
– Comply with the safety instructions and always remove the battery before
performing cleaning, maintenance or repair work.
Information!
The next service is stated on the press device and the press collar.
This service must be performed at least once a year. If more than 2500 pressing
operations are carried out in a year, a service must be performed after these 2500
operations, at the latest.
An LED indicates that the service interval is expiring 100 pressing operations in
advance (see Section 7.1 Meaning of the LED display).
28