Maintenance And Change Of Size - Degometal GO 171 Mode D'emploi

f2
f3
L
14
GB I
MAINTENACE AND CHANGE OF SIZE (fig. f4-f5-f6-f7)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For
this reason, it is necessary to lubricate the clamps after having
cleaned them with benzine or derivates. However, if clamps are
worn out and as a consequence their working is jeopardized,
replace them.
First remove the head which carries the nozzle (H), by means
of a standard spanner of 27 mm. Then, by using two standard
spanners of 18 mm and 14 mm, remove the chuck (M) and
extract the clamps (N).
C
The riveting tool is supplied, besides the nozzle series for
DEGOMETAL rivets, with a series of accessories for using
the rivets type FARBOLT, respectively of Ø 4,8 and Ø 6,4. For
operating with these rivets you have to replace the nozzles, the
clamps and the cone holding clamps.
When replacing the nozzle (A), use the proper supplied wrench
and screw the removed nozzle in it in order to avoid losing
the nozzle.
f4
Date 01-2017
WARNING!
Desconnect air feed when performing those
operations.
H
27 mm
GO 171 GO 171
Revisione - 08