Table Des Matières; Safety Measures And Requirements - Degometal GO 171 Mode D'emploi

INSTRUCTIONS FOR USE
INDEX
SAfETY MEASURES AND REQUIREMENTS . .......................10
TOOL IDENTIfICATION .......................................................10
MAIN COMPONENTS ..........................................................11
TECHNICAL DATA ...............................................................11
HOW TO USE YOUR RIVETING TOOL .................................11
MAINTENANCE AND CHANGE Of SIZE . ..............................12
TOOPING UP THE OIL-DYNAMIC CIRCUIT .........................12

SAFETY MEASURES AND REQUIREMENTS

CAUTION!!!
All the operations must be done in conformity
with the safety requirements, in order to avoid
any consequence for your and other people's
security and to allow the best tool work way.
• R ead the instructions carefully before using the tool.
• F or all maintenance and/or repairs please contact
DEGOMETAL authorized service centers and use only
original spare parts. DEGOMETAL may not be held
liable for damages from defective parts caused by
failure to observe what above mentioned (EEC directive
85/374).
• The tool must be used only by expert workers.
• A protective visor and gloves must be put on when using
the tool.
• Use equipment recommended in the maintenance chapter
to do any maintenance and/or regulation of the tool.
• For topping up the oil, we suggest using only fluids in
accordance with the features specified in this working book.
• If any drop of oil touches your skin, you must wash with
water and alkaline soap.
• The tool can be carried and we suggest putting it into its box
after using.
• The tool needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the
tool is not fed.
• If it is possible, we suggest a safety balancer.
• If the A-weighted emission sound pressure level is more
than 70 dB (A), you must use some hearing protections
(anti-noise headset, etc.).
• The workbench and the work surface must be always clean
and tidy. The untidy can cause damages to people.
• Do not allow unauthorized persons to use the working tools.
• Make you sure that the compressed air feeding hoses have
the correct size to be used.
12
I
GB I
• Do not carry the connected tool by pulling the hose. The hole
must be far from any heating sources or from cutting parts.
• Keep the tools in good conditions; do not remove either safety
parts or silencers.
• After repairing and/or adjusting, make sure you have already
removed the adjusting spanners.
• Before disconnecting the compressed air hose from the tool
make sure that there is no pressure in the hose.
• These instructions must be carefully followed.
WARNING!
Before using the tool, assemble the protection bottom
supplied with the tool, as indicated in the picture below.
DEGOMETAL has no responsibility for any damages
on the tool, persons or things caused by lack of the
protection bottom.
Date 01-2017
GO 171 GO 171
Revisione - 08