Tool Identification; Main Components; Technical Data - Degometal GO 171 Mode D'emploi

GO 171 GO 171

TOOL IDENTIFICATION

The riveting tool GO 171 is identified from a marking that shows
company name and address of manufacturer, designation of
the tool, CE. Always refer to the information on the riveting tool
when requesting technical service.
Designation of
ZI-1
06515 CARROS Cedex 1
the tool

MAIN COMPONENTS

A) ................................................................................. Nozzle
B) ............................................................Balancer connection
C) ............................................................................ Nails tank
D) . ........................................................ Suction opening lever
E) ....................................................... Tensile strenght button
F) ........................................................................Oil tank plug
G) . ............................................... Compressed air connection
H) . ............................................................Head carring nozzle
I) ................................................................ Protection bottom
L) .......................................................................... Nails baffle
A
H
Ø 24
D
E
340
G
Revisione - 08
Company name
and address
ère ème
Avenue,5 Rue
FRANCE
Serial number
B
F C
I
Ø145
GB I

TECHNICAL DATA

• Working pressure ......................................................6 BAR
• Min. int. diam. of the compressed
air feeding hose ................................... min. diam = 8 mm
• Air consumption per cycle ......................................... 10 Lt.
• Maximum force . .........................................6 BAR -17273 N
• Stroke ................................................................... 25.5 mm
• Weight .................................................................. 2.910 Kg
• Working temperature .............................................-5°/+50°
• Root mean square in total acceleration
frequency (Ac)
to which the arms are subjected ............................ 2,2 m/s
•
A-weighted emission sound pressure level
•
Peak C-weighted instantaneous sound pressure
•
A-weighted sound power
AIR FEED
The air feed must be free from foreign bodies and humidity
in order to protect the tool from premature wear and tear of
the components in movement, therefore we suggest to use a
lubrificator group for compressed air.
HOW TO USE YOUR RIVETING TOOL (fig. f1-f2-f3)
WARNING!
Before using the tool it is absolutely necessary to
fit the nails container (C), or the nails baffle (L).
Press lightly for assembling the nails baffle (L), as shown in
the figure f3.
After the clamping, the sheared nail is piped by the riveting
tool and ejected from the back. By swinging the lever (D) you
can activate the suction. By the suction nail system, the rivet
remains in the nozzle also turning over the head of the riveting
tool downwards: this detail increases a lot the usefulness of
the riveting tool.
Do not keep the rivet with your fingers!
If you use the nails tank (C), when it is full of nails do not use
the riveting tool. Disconnect the tool, unscrew the nails tank (C)
and empty it properly. DO NOT DISPERSE ANY NAIL! Screw
the nails tank (C) and start again to work.
Ø 60
f1
D
L
Date 01-2017
................. 67 dBA
...... <130 dBC
. .......................................... 80 dBA
2
13