Bosch Performance Line PowerPack 300 Notice Originale page 35

OBJ_BUCH-2272-001.book Page 8 Thursday, July 17, 2014 2:25 PM
On indicator r9, each bar of the battery pack symbol is equiv-
alent to a capacity of approx. 20 %:
The eBike battery pack is fully charged.
The eBike battery pack should be recharged.
The capacity for assisting the drive has been used
!
up, and assistance is gently switched off. The re-
maining capacity will be provided for the bike light
and the on-board computer.
The capacity of the eBike battery pack is enough
for about 2 hours of lighting. This does not account
for other consumers (e.g. automatic gearbox,
charging external devices at the USB port).
Nyon has never been inserted into the holder 4 or
!
Nyon has been reset to the factory configurations.
If the on-board computer is removed from the holder 4, the
last displayed battery charge level is saved.
Setting the Assistance Level
On the operating unit 11 you can set how much the eBike
drive assists you while pedalling. The assistance level can be
changed at any time, even while cycling.
Note: For individual versions, it is possible that the assistance
level is pre-set and cannot be changed. It is also possible that
less assistance levels are available for selection than listed
here.
The following assistance levels (max.) are available:
– "OFF": The motor assistance is switched off, the eBike can
be operated as a normal bicycle through pedaling.
– "ECO": Effective assistance at maximum efficiency for
maximum cruising range
– "TOUR": Uniform assistance, for touring with long cruising
range
– "SPORT": Powerful assistance for sportive riding off road
as well as for urban traffic
– "TURBO": Maximum assistance, supporting highest ca-
dence for sportive riding
To increase the assistance level, press the "+" 15 button on
the operating unit until the desired assistance level appears in
the display r5. To decrease the assistance level, press the
button"–" 14.
The requested motor output is displayed in indicator r4. The
maximum motor output depends on the selected assistance
level.
Assistance Level Assistance Factor*
(Derailleur)
"ECO"
50 %
"TOUR"
120 %
"SPORT"
190 %
"TURBO"
275 %
* The motor output can vary for individual versions.
Bosch eBike Systems
When the on-board computer is removed from the holder 4,
the last indicated assistance level is stored; the motor-output
indicator r4 remains empty.
Switching the Push/Start Aid On/Off
With the speed version, the push aid can also be used as a
start aid. The start aid is switched off at 18 km/h.
The push/start aid can make it easier for you to push or start
the eBike. The speed of this feature depends on the selected
gear and depending on the model, can reach a maximum of
6 km/h or 18 km/h. The lower the selected gear, the lower the
speed of this function (at full capacity).
 The push/start aid function may only be used when
pushing or starting the eBike. If the wheels of the eBike
have no contact with the ground when using the push aid,
then there is risk of injury.
To switch on the push/start aid, press and hold the "WALK"
16 button on the operating unit. The eBike drive is switched
on.
The push/start aid is switched off if one of the following
occurs:
– you release the "WALK" 16 button,
– the wheels of the eBike are blocked (e.g. by actuating the
brakes or impacting against an obstacle),
– the speed exceeds 6/18 km/h.
Switching bike lights on/off
In the model, in which the lighting is powered by the eBike
system, the front and rear light can be switched on and off at
the same time via the on-board computer with the button 6.
The illumination symbol s1 is displayed when the light is on.
Switching the bike light on and off has no effect on the back
lighting of the display.
English–8
0 276 001 SPN | (17.7.14)