Star SP500 Série Mode D'emploi page 116

I DIP switch
SW No.
1 Always ON
2 Auto Cutter
3 Always ON
4 Command emulation
5
Baud Rate
6
7 Data Length
8 Parity Check
9 Parity
10 Handshake
*1 The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch 2 = on)
Models with auto cutter: Valid (Switch 2 = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e.,
models with a tear bar). A mechanical error will occur.
Baud Rate
4800BPS
9600BPS
19200BPS
38400BPS
Function
Switch 5
OFF
ON
ON
OFF
– 113 –
Factory presetting: All ON
ON
Should be set on
Invalid
Should be set on
Star ESC/POS
See table below
8 bits
Disabled Enabled
Odd
DTR/DSR XON/XOFF
Switch 6
ON
ON
OFF
OFF
*1
OFF
Valid
7 bits
Even