Troubleshooting - Scheppach HL1020 Traduction Des Instructions D'origine

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and elec-
tronic equipment (WEEE). This product must be dis-
posed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.

17. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Malfunction
The hydraulic pump does not
start
The column does not move
down
Motor starts but column does
not move down
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
No electric power
Thermal switch of motor cut off
Low oil level
One of the levers not connected
Dirt in the rails
Wrong turning direction of 3-phase
motor
Remedy
Check cable for electric power
Engage thermal switch inside the motor casing
again
Check oil level and refill
Check fixing of lever
Clean the column
Check turning direction of motor and change
GB | 25