Setting The Temperature; Switching Off; Automatic Switch-Off Time; Cleaning And Maintenance - Beurer HK 37 To Go Mode D'emploi

WARNING
If the heat pad is being used over several hours, we recommend that
you set the lowest temperature setting to avoid overheating the heated
body part, which may lead to burns to the skin.
NOTE
When the powerbank (4) has been almost completely run down, the heat pad is switched off
automatically to protect the powerbank. The powerbank must then be charged.

4.6 Setting the temperature

OFF: On/Off button (2) not lit
Setting 1: Minimum heat (LED display of the On/Off button lights up green)
Setting 2: Medium heat (LED display of the On/Off button lights up yellow)
Setting 3: Maximum heat (LED display of the On/Off button lights up red)

4.7 Switching off

Press the On/Off button (2) to switch off the heat pad (1). The switching sequence is 1 ­ 2 ­ 3 ­ OFF ... If the
heat pad is switched off, the LED display of the On/Off button goes out immediately and the LED display on
the powerbank (4) goes out after a few seconds.
NOTE
Please note that the powerbank (4) must be protected against extreme cold to maintain its full
performance.

4.8 Automatic switch-off time

This heat pad (1) is equipped with an automatic switch­off function. This turns off the heat supply approx.
110 minutes after the initial use. The On/Off button (2) on the heat pad and the white LED display on the
powerbank go out.
You can switch the heat pad on again immediately by pressing the On/Off button. If it is no longer possible
to switch the heat pad on, then the powerbank has been run down.

5. Cleaning and maintenance

IMPORTANT
• Before cleaning, always first disconnect the powerbank (4) from the heat pad (1). Remove the pow­
erbank from the heat pad's pocket. Otherwise there is a risk of damage.
IMPORTANT
• The powerbank (4) must never come into contact with water or other liquids as this may cause
damage.
To clean the powerbank (4), use a dry, lint­free cloth. Do not use any chemical or abrasive cleaning agents.
IMPORTANT
• Please note that the heat pad (1) must not be chemically cleaned, wrung out, tumble dried, put
through a mangle or ironed. Otherwise the heat pad may be damaged.
This heat pad is machine­washable. To do this, place the connecting cable (3) into the built­in pocket (5)
and place the heat pad (1) in a wash bag. Set the washing machine to a particularly gentle wash cycle at
30°C (wool cycle).
For ecological reasons, always wash the heat pad (1) together with other textiles.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
15