Storage; Disposal; What If There Are Problems - Beurer HK 37 To Go Mode D'emploi

IMPORTANT
• Please note that washing the heat pad (1) too frequently has a negative effect on the product.
The heat pad should therefore be washed in a washing machine a maximum of 10 times during its life.
Let the heat pad dry flat on a clothes horse.
IMPORTANT
• Do not use pegs or similar items to attach the heat pad (1) to the clothes horse, otherwise the
heat pad may be damaged.
• Only reconnect the heat pad to the powerbank (4) once the heat pad and the connector plug of
the connecting cable (3) are completely dry. Otherwise the powerbank and the heat pad could be
damaged.

6. Storage

If you do not plan to use the heat pad for a long period of time, we recommend that you store it flat and
spread out. Always remove the powerbank. Ensure there are no sharp folds in the heat pad at any time.
IMPORTANT
Please allow the heat pad (1) to cool down before storing, otherwise the heat pad may be damaged.
To avoid sharp folds in the heat pad, do not place any heavy objects on top of it while it is being stored.
IMPORTANT
Place the powerbank (4) in a dry, dust­free and cool place, away from direct sunlight. The powerbank
should be charged once a year to retain its capacity.

7. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
service life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
The empty, completely flat batteries must be disposed of through specially designated collection boxes,
recycling points or electronics retailers. You are legally required to dispose of the batteries.

8. What if there are problems?

Problem
The LED display of the On/Off button (2)
on the heat pad (1) and the white LED
display on the powerbank (4) do not light
up when:
– the powerbank is connected to the heat
pad and
– the On/Off button has been pressed.
The LED display of the On/Off button (2)
on the heat pad (1) and the white LED
display on the powerbank (4) do not light
up when:
– the fully charged powerbank is con­
nected to the heat pad and
– the On/Off button has been pressed.
Cause
The powerbank has been fully run
down.
There was a SAFETY SWITCH­OFF
due to a fault in the heat pad.
The heat pad or the powerbank is
faulty.
16
Solution
Charge the powerbank.
Allow the heat pad to cool
down to room temperature
and switch it on again.
Send the heat pad and the
powerbank for servicing.