Operation; Safety; Initial Use; Switching On - Beurer HK 42 Supercosy Mode D'emploi

4. Operation

4.1 Safety

CAUTION
The heating pad is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the heating pad with an automatic switch-off in the event of a
fault. If the SAFETY SYSTEM has switched off the heating pad, the temperature settings are no longer
illuminated when switched on. Please note that for safety reasons, the heating pad can no longer be
operated after a fault has occurred and must be sent to the specified service address.

4.2 Initial use

CAUTION
Ensure that the heating pad will not bunch up or become folded during use.
• First, connect the controller to the heating pad by inserting the plug-in coupling.
• Then plug the mains plug into the socket.

4.3 Switching on

To switch the heating pad on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings (4) are illuminated when switched on.

4.4 Setting the temperature

Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOTE:
The fastest way to warm up the heating pad is to initially set the highest temperature setting.
NOTE:
These heating pads have a fast heating function, which allows the pad to warm up faster
in the first 10 minutes.
WARNING
If the heating pad is being used over several hours, we recommend
that you set the lowest temperature setting on the controller to avoid
overheating the heated body part, which may lead to burns to the skin.

4.5 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat sup-
ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display
then starts to flash. So that the heating pad can be switched back on, the sliding switch for ON/
OFF and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds
it is possible to switch it on again.

4.6 Switching off

To switch the heating pad off, set the sliding switch for ON/OFF and temperature settings to setting "0" (OFF).
The temperature settings are then no longer illuminated.
12
90
min
STOP