Güde GH 2800 Traduction Du Mode D'emploi D'origine page 11

Introduction
Please read thoroughly this operation manual and
attached safety instructions to enjoy your new electric
garden waste shredder. We further recommend to retain
the operation manual for future references. We reserve
right to make technical changes for the purpose of
improvement in the course of continuous product
development.
This is the original operation manual.
Scope of supply
Unpack the appliance and check completeness and
delivery of the following components:

GH 2800 P

filling hopper

pusher

collection bag or box

original user guide
Please contact your seller if you either miss some
components or the components are damaged.
If assembled, weight of the appliance is 23.5 and 28 kg,
respectively. If needed, two persons may lift the appliance
from the packing.
Description of the appliance
Sturdy and quiet shredder with rolling technology and
reverse operation feature. Ideal for cutting of branches and
bushes; the garden waste is processed in fine chips by
simultaneous cutting by blades and roll crushing for faster
composting. Automatic drawing of crushed material up to
40 mm in diameter in, direct drive and undervoltage
switch.
GH 2800 P #94375 (Fig. E)
1. overload safety feature
2. Start pushbutton (green), Stop pushbutton (red)
next to it
3. forward and reverse operation pushbutton
3A. forward operation feature
3B. reverse operation feature
4. filling hopper
5. plug
6. set screw for crushed material size control (Fig.
H/13)
7. collection box
8. side holder of the collection box
9. leg
10. transport wheels
11. collection box clamping lever (Attention! the
appliance does not start without clamping.)
Technical data
ELECTRIC GARDEN WASTE SHREDDER GH 2800
#94375
Voltage/frequency:
Engine power:
Engine max. revolutions:
Protection type:
Max. branch diameter:
Collection bag volume:
Noise level:
Dimensions LxWxH (in mm):
Weight:
*
Noise information
Noise values were measured according to 2000/14/EC
230V~50Hz
2800W (P1;S6 40%)**
-1
2994 min
IPX4
max. 40mm
60l
L 86dB *
WA
640x485x860
28kg
(1.60m height, 1m distance) - measurement tolerance +-
3dB
**
Operation mode S6 40% indicates load profile: 40 seconds
load and 60 seconds idle operation, long-term operation is
acceptable for normal operation.
General safety instructions
Read this user guide thoroughly. Make sure you know the
controls and correct use of the appliance. Store the user
guide safely for future reference.
Safe work
Keep your workplace tidy!
Disorder on workplace may result in injuries.
Consider surrounding conditions!
Do not expose to rain.
Do not use in moist or wet environment.
Provide good lighting.
Do not use close to flammable liquids or gases
Keep other persons in a safe distance!
Other persons, particularly children, may not touch the
device and power cable. Keep them in a sufficient distance
from your workplace.
Store your device properly!
The device, if not used, should be stored in a dry and
closed space, out of reach of children.
Do not overload your device!
Operate the appliance within specified working capacity.
Use correct device!
Do not use the device for purposes other than intended.
Take care of your appliance!
Observe maintenance directions and instructions.
Check appliance cable regularly and ask an authorized
specialist to replace the same if damaged.
Check extension cable regularly and replace, if damaged.
Keep handles dry, without traces of oils and greases.
Be careful!
Be aware of what you are doing. Approach your work with
sound mind. Do not use the device if you are tired.
WARNING!
Use of non-compliant accessories may result in an injury.
Have your device repaired by an electrician only!
This device complies to applicable safety provisions.
Repairs may be performed by an electrician with the use of
genuine spare parts, otherwise the user may be exposed
to injury hazard.
Safety instructions specific for this device
Turn the appliance off and unplug the appliance from
socket before working with cutting mechanism.
If the power supply cable either cuts or gets damaged
during operation, do not touch the cable but deactivate the
safety feature of relevant electric circuit.