Whirlpool PACW29COL Directives D'utilisation page 14

Remote controller
Insert the batteries into RC
1. Insert a pin and gently press down on the battery
cover and push in the direction of the arrow to
remove, as shown.
2. Insert 2 AAA batteries (1.5V ) into the compartment.
Ensure that "+" and "-" polarity is correctly positioned.
3. Close the battery cover on the remote control.
• Remote Control presetting
Each time the batteries are replaced in the remote
controller, the remote controller pre-set at Heat Pump
mode. The heat pump AC remote controller can be used
to control the cool only AC models.
• The remote control will operate the air conditioner at a
distance of up to 7m.
Note: please follow the intruction which matches to the remote controller you receive for Air Conditioner
operation.
Function description of buttons
1.
ON OFF BUTTON
Starts and/or Stops the appliance by pressing this button.
2.
MODE BUTTON
Used to select the operation mode.
3.
FAN BUTTON
Used to select fan speed in sequence auto, high, medium or low.
4-5. TEMPERATURE BUTTON
Used to select the room temperature. Used to set time in timer mode and real
time clock.
6. 6th SENSE BUTTON
Sets or cancels 6th Sense operation.In this mode,temperature and fan speed are
automatically set based on the actual room temperature.
7. SWING BUTTON
Stops or starts horizontal adjustment louver swinging and sets the
desired up/down airflow direction.
8. SLEEP BUTTON
1) Short press,sets or cancels Sleep Mode operation.Sleep Mode can be set in Cooling
Heating or Dry operation mode,this function gives you a more comfortable
environment for sleep.
2) Long press,press 3 senconds to turn on or turn off display light on unit.
9. AROUND U BUTTON
Used to start or cancel Around U function.When you press this button,remote control
transmits the actual room temperature around it to the indoor unit,and the appliance
will operate according this temperature to let you feel more comfortable.
10. TIMER BUTTON
Used to set or cancel the timer on operation.
Used to set or cancel the timer off operation.
11. SILENT BUTTON
Used to set or cancel the Silent operation.Press silent button to let the unit operate at low noise level to get quiet and
comfortable room environment.
Note:Under extreme environmental conditions,it is possible to notice a temporary slight increase in noise due to the need of reaching the comfort
temperature quickly.
Symbols on RC display
Cooling indicator
Dry indicator
Fan only indicator
Heating indicator
Auto fan speed
High fan speed
Medium fan speed
Low fan speed
-14-
Use RC to control the appliance
• To operate the appliance by remote control, point the
remote control at the receiving device on the indoor
unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
will flash for 1 second. On receipt of the message, the
appliance will emit a beep.
Signal receptor
6th Sense indicator
Sleep indicator
Around U indicator
Silent indicator
Signal transmission
Display set timer
Display set temperature