Trouble.shooting - FLORABEST FHE 550 B2 Traduction Du Mode D'emploi D'origine

GB
Trouble shooting
Problem
Device does not
start
Inferior cutting
performance
Saw runs with
difficulty, chain
(1) comes off
Chain (1)
becomes hot,
smoke develop-
ment during
sawing, discol-
oration of the
rail
68
Possible.cause
Mains voltage defective
House protection fuse activated
Defective On/Off switch (10)
Worn carbon brushes
Defective motor
Incorrectly mounted saw chain
(1)
Saw chain (1) blunt
Chain tension insufficient
Chain tension insufficient
Too little chain oil
Fault.correction
Check plug socket, cable, line and
plug, where appropriate, repair by
electrical specialist.
Check house protection fuse, see note
Repair by customer service
Repair by customer service
Repair by customer service
Mount saw chain correctly
Sharpen cutting teeth or place on
new chain
Check chain tension
Check chain tension
Check oil level and, where appro-
priate, refill with chain oil,
check oil automatic system and,
where appropriate, clean oil out-
flow duct 17 or have repaired
D
by customer service
Check fine-tuning for lubrication
system (oil regulation button).