Snap-On MH 310 PRO Mode D'emploi page 42

MH 310 PRO
MH 320 PRO
42
D
iii-3
iii-4
Appendix
Type D casing (lowered casing, sloping wide beam)
fi gure iii-3
On this type of tyre changer (known as a Racing type),
mount the device directly on the sloping beam.
- For units without thread under the sloping beam,
use the longest screws and the locknuts with washers.
- In units with integrated thread under the beam, use
the screws with 10 mm diameter and 100 mm length,
supplied with the equipment.
Immobilise the moving parts of the device.
•
• Lift the device with appropriate lifting gear (crane, Lift the device with appropriate lifting gear (crane,
•
fork lift truck) and a band with suffi cient load-bearing fork lift truck) and a band with suffi cient load-bearing
capacity (220 lbs.-100 kg).
capacity (100 kg-220 lbs.).
• Fix the device to the bead breaker arm support
Fix the device to the bead breaker arm support
•
with the screws, washers and nuts supplied. Insert with the screws, washers and nuts supplied. Insert
the fi xing elements, as illustrated and specifi cally the fi xing elements, as illustrated and specifi cally
described.
described.
Horizontal arm (Only for MH 310 PRO):
Insert the hexagonal rod with the roller in the lower
•
seat of the mobile guide, as shown fi gure iii-4.
WARNING: INCORRECT ROD INSTALLATION CAN
DAMAGE THE TYRE.
Operator's Manual