Table des Matières
Publicité
MH 310 PRO
MH 320 PRO
38
ii-1
ii-2
Appendix
i. Installation requirements
THE INSTALLATION SHALL BE CARRIED OUT ONLY
BY QUALIFIED PERSONNEL AND WITHIN THE
SCOPE OF THE INSTRUCTIONS PROVIDED IN
THIS MANUAL.
Install the machine in a covered and dry area.
Make sure that from the operating position the user
can see all of the machine and the surrounding area.
The operator shall forbid, in such an area, the presence
of non authorized persons and of objects which may
create possible hazards.
ii. Carriage – Uncrating - Moving the machine
Carriage
The machine is crated in a corrugated box of
appropriate strength. The box is mounted on a pallet.
Handling of the machine must be made with an
appropriate lifting device (fork lift) (Fig.ii-1).
Uncrating
ALWAYS WEAR GLOVES WHEN UNCRATING
THE MACHINE TO PREVENT SCRATCHES OR
ABRASIONS DUE TO CONTACT WITH PACKING
MATERIALS.
Uncrate the machine paying attention when cutting
the plastic straps or during any other operation which
may be hazardous.
After removing the carton check for any visible damage
to the machine and its components.
In case of doubt call qualifi ed personnel for assistance.
The packing materials (plastic bags, polystyrene, nails,
screws, wood etc.) must be properly disposed of. Place
the above mentioned materials into a trash container
and dispose per local regulations.
Moving the machine
The device can be moved only with the machine that
it is fi tted to. Ensure that all the mobile elements of the
device are blocked.
Follow all the indications provided on the user manual
of the relative tyre changer.
Ensure that there is suffi cient space in order to avoid
crushing and entrapment conditions (Fig. ii-2).
Ensure that from the operating position the user can
see all of the machine and the surrounding.
The operator shall forbid, in such an area, the presence
of non authorized persons and of objects which may
create possible hazards.
Operator's Manual
Publicité
Table des Matières
