Brandt WTD 1276 Guide D'installation & D'utilisation page 29

4 / PROGRAMMING YOUR MACHINE
•MODIFYING A WASHING
PROGRAMME
•During programming:
You can alter anything before you press the "Start /
Pause" button 2 .
•After the cycle starts:
— You cannot alter the type of textile (for example,
change from «COTTON» to «SYNTHETICS» or
from «SYNTHETICS» to «WOOLLENS», etc.).
NB:
- If you turn the programme selector
different textile, the progress cycle light
lit at the time, and the display
seconds to indicate that such an alteration is
prohibited and will not be effected.
- To change the type of fabric during the cycle, you
must cancel the current programme and then
programme a new cycle.
— However, you can change the washing
temperature at the start of the washing phase for
the same type of textile.
NB: The time remaining will then be adjusted
accordingly.
— You can also change the spin speed throughout
the cycle.
— You can select "Drip-dry" and "Full drum stop" up
to the end of rinsing.
— You can activate option "
the point that rinsing commences.
— You can deactivate all the options at any time
during the cycle provided that the particular action
has not already been completed.
— You cannot programme or modify a drying after
the start of a washing or drying cycle.
1
to a
B which is
A
flash for a few
" (Rinse plus) up to
29
During delayed start:
— Any kind of programme modification is accepted
during a delayed start's waiting period.
— You can change the period for a "delayed start"
period throughout the whole of the waiting period,
right up to the effective cycle starting time.
NB:
- During this period, selecting a new time cancels
out the previous selection. The new period selected
is accepted based on the last selection made.
- If you wish to cancel "Delayed start" during this
A
period, set display
button 2 .
The cycle will then start immediately.
— You can only activate option "
during the waiting period for a "Delayed start".
— You can only modify the options "
ironing), " " (Eco) and "
waiting period for a "Delayed start".
•When the cycle is over:
When the display shows "- 0 -", you can programme
a new cycle without having to press the "On/Off"
I / O button again.
To do this, all you need to do is to press one of the
2 3 4
buttons , , or
The machine is then ready to be
reprogrammed.
to "0" and then briefly press
" (Prewash)
" (Easy
" (Intensive) during the
R
.
EN