Automatic Safety Systems - Brandt WTD 1276 Guide D'installation & D'utilisation

EN 4 / PROGRAMMING YOUR MACHINE
•DETAILS OF THE OPTIONS
( )
continued
•Delayed start
You can delay the start of your programme by 1 to
19 hours to take advantage of off-peak rates or
finish the cycle at a particular time.
To do this, press button
(delayed start). Then press button
the cycle starting time.
NB: While the machine is waiting to start, display
shows the time remaining before the cycle
effectively starts.
•Remaining time
During programming, pressing button
3 lights " ", " " and " " go out lets you know
the length of the selected cycle*.
(*) The time indicated by the machine at the start of
the programme may vary during the course of the
cycle:
- If you change the washing temperature (even
during a spin) or if you add or cancel options, the
time will be recalculated and updated on the
display.
- Certain operating variables (for instance: detection
of imbalance or foam, etc.) can also alter the cycle's
duration.
- If there is a power failure during washing, when the
power is restored, the time displayed may be less
than the actual remaining time. This time will be
updated at the start of the rinsing phase.
•Full drum stop
This is used for textiles that you do not wish to spin
or if you envisage being absent for a long time after
the washing is finished.
When this function is selected, the cycle interrupts
before the final spin, enabling your washing to soak
in the water to avoid creasing.
NB: When the machine stops with the drum full of
A
water, display
remaining but remains fixed (including the point).
Then:
— You either wish to drain and spin.
In which case, select the Spin function " " using
3
button then use button
speed for your type of washing.
The programme will shut down automatically.
— Or you just wish to drain.
In which case, select the Spin function " " and
then use button
R
function).
3
and select function "
R
land select
3
does not count off the time
R to set a suitable spin
to display ("Drip-dry"

•AUTOMATIC SAFETY SYSTEMS

• Lid opening safety system:
As soon as washing commences, the lid on your
machine is locked.
When the cycle is finished or when the machine has
stopped with the drum full of water, the lid unlocks.
"
If you have programmed a "Delayed start", the lid is
not locked until the waiting period is over and the
cycle starts.
A
If you wish to open the lid during the cycle, press
button 2
system to unlock the lid.
•Water safety system:
until the
During operation, constant control of the
water prevents any overflows.
•Spin safety system:
Your washing machine is fitted with a safety
system that restricts the spin when poor load
distribution is detected.
In this case, your washing may be
insufficiently spun. Redistribute your washing
in the drum and programme a new spin.
•Anti-foam system:
You machine can detect when too much foam
is being produced during spinning.
At such times, spinning stops and the
machine drains.
The cycle then restarts, adapting the spin
rates and possibly adding an extra rinse.
28
briefly and wait 1-2 minutes for the safety