Connecting To The Electricity Supply; Installing Your Machine - Brandt WTD 1276 Guide D'installation & D'utilisation

2 / INSTALLING YOUR MACHINE

•CONNECTING TO THE
ELECTRICITY SUPPLY
Important:
For your safety, you must comply with the
instructions below.
— Before connecting your machine, you must
ensure that your installation's electrical
characteristics match those of your machine (see
the details provided on the information plate affixed
to the back of the machine).
The electrical installation must comply with the
prevailing standards and the Electricity Board's
regulations in the country concerned, particularly
as regards Earthing and installation in shower
rooms.
We cannot be held responsible for any incident
caused by the machine being incorrectly earthed.
Advice:
Advice on the electrical installation of
your machine
— Do not use an extension lead, adapter or multiple
socket.
— Never cut out the Earth wire.
— The socket must be readily accessible but out of
the reach of children.
If in any doubt, please contact your installer.
Important:
Your machine conforms to European
Directives 2006/95/CE (Low Voltage Directive)
and 2004/108/CE (Electromagnetic
Compatibility).
•REPLACING THE POWER SUPPLY
CABLE
Warning:
For your safety, the power cable and,
depending on the model, the complete electric
box and its associated cable must only be
replaced by the manufacturer's After-Sales
Service or a qualified electrician.
•MOVING YOUR MACHINE
•Setting on castors
To move your machine, unclip and slide the castor
release handle from right to left (Fig. 4 ➀ ) .
Important :
Your machine must not still be on its
castors when in operation: remember to return the
lever to its initial position.
• INSTALLING YOUR MACHINE
Important:
If you are installing your machine next to
another machine or a unit, we recommend that
you leave a gap between them to allow for air
circulation.
Advice:
We also strongly recommend that you
do NOT:
— Install your machine in a damp, poorly ventilated
room.
— Install your machine in an area where it could be
subject to water splashes.
— Install your machine on a carpeted floor.
If you cannot avoid doing this, please take every
precaution to avoid blocking air circulation at the
bottom of the machine in order to ensure that the
internal components are well ventilated.
• For washer-dryers:
— The appliances must not be installed behind a
lockable door or a sliding door.
• Levelling the machine
— Set your machine on its castors.
— Unscrew the two screws with a straight-edged
screwdriver ( Fig. 4 ➁ ) .
— Level the machine by adjusting the two feet using
a flat spanner or a pair of pliers.
— Set the machine back on the floor by sliding the
castor release lever to check the chocking.
— If the machine is correctly level, retighten the two
locking screws.
NB: To align your machine with your units, you can
break off the fixing hooks for the hoses.
Take care not to squash the hoses!
4
➁
21
EN
➀