Explanation Of Symbols; Operating Instructions; Overview; Charging The Power Packs - EAL APA 16540 Manuel De L'opérateur

eyes, rinse immediately for at least 10 minu-
tes under clear, running, lukewarm water!
Then consult a physician immediately!
• If acid has spilled onto clothing, wash it out
with plenty of soap and water.
• Never wear rings, necklace, watches, etc.
when handling batteries or chargers. There
is a risk of fi re and explosion if the battery
contacts short circuit!
• The power pack is only designated as a star-
ter aid for a vehicle with an own battery. The
power pack cannot replace the vehicle battery.
• Always store the terminal clamps in the de-
signated holder to prevent any short circui-
ting when the power pack isn't being used.
• Do not attempt to remove and replace the
battery of the power pack. Once the battery
life is over, dispose
of the entire power pack in compliance with
local disposal regulations.
• Do not charge the battery of the power pack
with a damaged charger.
• Use only the charging accessories that are
included with the device.
• Never attempt to start a frozen battery, as
this could cause an explosion.

5. EXPLANATION OF SYMBOLS

In accordance with EC guidelines
Labelled electrical product may not be
disposed of in the household waste
Devices with this label may only be operated
indoors (dry enviroments)
Protective insulated hou-
sing (protecion class II)
Fail-safe safety
transformer (deactivates
permanently in the event
F
of a fault)
Corresponds to the requierements of § 21 of
the German Product Safety Act (ProdSG)
Labelling in acc. with § 17 German battery
law (BattG): The end
consumer is legally obligated to proberly
dispose of the product by returning it to rhe
point of sale or an authorized disposal point
8

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1
2
3
4
5
6
7
8
9
10 Manometer
11 ON/OFF switch for compressor
12 Air hose with car valve connection
13 Pole callipers, red (+)
14 Motor vehicle charging cable
15 Plug charger
16 Valve adapters
Fuse, here:
1.0 A
Fig. 1: Overview Fig. 1: Overview

6.2 CHARGING THE POWER PACKS

Read
The power pack is delivered partially charged. After initial
Instructions
purchase/prior to fi rst use, make sure that the power pack
is fully charged.

6.2.1 CHARGING WITH THE PLUG-IN CHARGER

Turn the on-off switch (position 1 in the overview) to
the OFF position. Plug the coaxial power connector of
the plug-in charger (position 13 in the overview) into
the charging socket of the power pack (position 4 in the
overview). Now plug the plug-in charger into the socket.
Switch for starting aid
Switch for working light
Control lamp for starting aid / incorrect poles
Charging socket
Working light
Control button for charge status
Control lamp for charge status
12 V motor vehicle socket
Pole callipers, black (-)