Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL CC-HS 12 Instructions D'origine

Apply the drive bit to the screw head and press
the ON/OFF switch.
Carefully insert the bolt or nut in the thread before
you actuate the electric screwdriver. A torque of
approximately 40-50 Nm per pulse is generated
on standard bolts of size M12/M14. On motor
cars, each bolt should be tightened with two pul-
ses. Each bolt should then be checked with one
additional pulse. A total torque of between 120
and approximately 150 Nm is thus achieved.
Three pulses are recommended on heavy vehic-
les (e.g. luxury cars, off -road vehicles, etc.). Each
bolt should then be tightened in diametrically
opposed order with one additional pulse. A total
torque of approximately 170 - 230 Nm is thus
achieved.
Check the threaded connections for signs of da-
mage after tightening.
Important!
Always tighten and check wheel nuts with a
torque wrench set to the torque specifi ed by
the manufacturer of the vehicle in question.
6. Cleaning, maintenance and
ordering of spare parts
6.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
6.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_CC_HS_12_SPK1.indb 15 Anl_CC_HS_12_SPK1.indb 15
GB
6.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
6.4 The following are excluded from the war-
ranty:
•
Wearing parts
•
Damage resulting from improper use or
tampering by third partiesrequire additional
maintenance.
7. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
8. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 15 -
13.04.16 10:57 13.04.16 10:57