Safety Regulations; Layout And Items Supplied - EINHELL CC-HS 12 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Practise these safety precautions to protect your-
self and your surroundings from accident hazards.
•
Use the hammer-action screwdriver only as it
is intended.
•
Keep tools out of the reach of children.
•
Only begin work if you are well-rested and not
distracted.
•
Disconnect the tool from the power supply
before beginning any trouble-shooting or
maintenance work.
•
Use only original spare parts.
•
Never run the tool at full idling speed with no
load for an extended time.
•
Wear protective clothing whenever you work
with the screwdriver.
•
Wear ear protection and gloves!
•
This appliance is not intended for use by per-
sons (including children) with reduced phy-
sical, sensory or mental capabilities, or lack
of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety. Children should
be supervised to ensure that they do not play
with the appliance.
•
Hold the equipment by the insulated handles
when carrying out work during which the
screw could strike concealed power cables
or the equipment's own mains lead. Contact
Anl_CC_HS_12_SPK1.indb 13 Anl_CC_HS_12_SPK1.indb 13
GB
between the screw and a live cable can also
make the metal parts of the equipment live
and will cause an electric shock.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1 ON/OFF switch
2 Reversing switch
3 operating LED
4 Square drive mount (mounting shaft)
5 12V connecting plug with internal fuse
6 adapter cable
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
1 screwdriver with hammer action, 12 V/d.c.
•
1 plastic carrying case
•
Set of drive bits size 17, 19, 21 and 23 mm
(one of each)
•
1 adapter cable
•
Original operating instructions
- 13 -
13.04.16 10:57 13.04.16 10:57