Technics OTTAVA SC-C500 Manuel D'utilisation page 45

"F " (" " stands for a number.)
• There is a problem with this unit.
- Is the volume extremely high?
If so, lower the volume.
- Is this unit placed in an extremely hot place?
If so, move this unit to a cooler place and
wait a few moments and then try to turn it
on again.
If the problem persists, write down the
displayed number, disconnect the AC power
supply cord and consult your dealer.
Load Fail
• The firmware on the USB flash memory cannot
be found.
• Download the latest firmware on the USB flash
memory and try again. ( 40)
No Device
• No USB device is connected.
• Connect the USB device to be played. ( 26)
No Disc
• No CD is inserted.
• Insert the disc to be played ( 24).
No Network Available
• This unit is not connected to the network.
• Check the network connection. ( 18)
No Play
• The disc cannot be played back.
• Insert the disc to be played ( 46).
Not Valid
• The function you have tried to use is not
available with the current settings. Check the
steps and settings.
PGM Full
• The number of programed tracks is more than
24.
Please Wait
• This is displayed, for example, when this unit
is turned to standby/on. (For up to approx.
1 minute and 30 seconds)
Reading
• The unit is checking the CD information. After
this display has disappeared, start operating.
"Remote " (" " stands for a number.)
• The remote control and this unit are using
different codes.
Change the code on the remote control. ( 15)
Remote Mode
• Basic playback control buttons on the touch
panel/remote control are not available. (While
playing back music stored on the DLNA server
with this unit (DMR), etc.)
• Use the connected device for basic playback
control.
Searching
• The unit is checking the DLNA server on the
network.
Unlocked
• "PC" is selected, but a PC is not connected.
Check the connection with the PC. ( 31)
• The sampling frequency components, etc. of
the audio signals are not input correctly.
- About supported format, refer to "File
format" ( 50)
USB Over Current Error
• The iPhone/iPad/iPod or USB device is drawing
too much power. Disconnect the iPhone/iPad/
iPod or USB device and turn the unit to standby
and on again.
Wi-Fi Setup
• Select "On" and press [OK] to enter the
network setting. ( 19)
- To exit the network setting, select "Off" and
press [OK].
Hub Device Not Supported/Not Supported/
Device Not Recognized/USB Device Not
Supported
• You have connected an iPhone/iPad/iPod or
USB device that is not supported.
- If the iPhone/iPad/iPod is compatible, turn it
on and connect it correctly.
• The format of the file on the iPhone/iPad/iPod
or USB device is not supported.
- About supported format, refer to "File
format" ( 50)
45
Troubleshooting (45)