Bluetooth - Technics OTTAVA SC-C500 Manuel D'utilisation

Troubleshooting
Playback does not start.
• Depending on your environment or connected
devices, it may take some time.
• Check to see if the format of the file is
supported. About supported format, refer to
"File format". ( 50)
The unit turns to standby mode
automatically.
• Is the auto off function turned on? ( 38)
• This unit incorporates a protection circuit
to prevent damage caused by heat buildup.
When you use this unit at a high volume
level for a long period of time, it may turn
off automatically. Wait for this unit to cool
down before turning on this unit again. (For
approximately 3 minutes)
The settings are reset to the factory
defaults.
• Updating the firmware may reset the settings.
Disc
Incorrect display or play does not start.
• Make sure that the disc is compatible with this
unit. ( 46)
• There is moisture on the lens. Wait for about
an hour and then try again.
• Unfinalized CD-R and CD-RW cannot be played
back.
• WMA/MP3 is not supported. Refer to "Notes
on CDs" ( 46) for information about the discs
this unit can play back.
Playback takes time to start.
• It may take some time for the disc to load if
there are a lot of tracks on it.
USB
The USB drive or its contents cannot be
read.
• The USB drive format or its contents is/are not
compatible with the unit. ( 46)
No response when [
• Disconnect the USB device and then reconnect
it. Alternatively, turn the unit to standby and
on again.
Slow operation of the USB flash drive.
• Large file size or high memory USB flash drive
takes longer time to read.
• It may take some time if there are a lot of files
or folders on it.
42
(42)
] is pressed.
iPhone/iPad/iPod
Cannot operate.
• Select "USB" as the input source. ( 27)
• Check that the iPhone/iPad/iPod is connected
properly. ( 27)
• The battery of the iPhone/iPad/iPod is
depleted. Charge the iPhone/iPad/iPod, and
then operate again. ( 27)
• Connect the iPhone/iPad/iPod again or try to
restart the iPhone/iPad/iPod.
iPhone/iPad/iPod does not charge.
• Only when unit is ON will charging begin from
USB cable connection.
• Make sure the unit is turned on when you start
charging.
- When charging an iPhone/iPad/iPod whose
battery is depleted, do not turn this unit to
standby mode until the iPhone/iPad/iPod
becomes operational.

Bluetooth

®
Pairing cannot be completed.
• Check the Bluetooth device condition.
®
The device cannot be connected.
• The pairing of the device was unsuccessful or
the registration has been replaced. Try re-
pairing the device.
• This unit might be connected to a different
device. Disconnect the other device and try re-
pairing the device.
The device is connected, but audio cannot
be heard through this unit.
• For some built-in Bluetooth
to set the audio output to "SC-C500" manually.
Read the operating instructions for the device
for details.
The sound is interrupted.
• The device is out of the 10 m (33 ft)
communication range. Bring the Bluetooth
device closer to this system.
• Remove any obstacle between this system and
the device.
• Other devices that use the 2.4 GHz frequency
band (wireless router, microwaves, cordless
phones, etc.) are interfering. Bring the
Bluetooth ® device closer to this system and
distance it from the other devices.
• Select "Mode1" for stable communication.
( 29)
devices, you have
®
®