Publicité
Les langues disponibles
Les langues disponibles
f. Switch on and off (Fig. 8)
Fig. 8
3. Operation for working
a. Sanding
!
Do not touch the gear box after prolonged use; it could be very hot.
WARNING
• The removal rate and the sanding pattern are determined by the choice of sanding
sheet and the work surface.
• Apply uniform sanding pressure to extend the life of the sanding sheets.
• Intensifying the sanding pressure does not lead to an increase of the sanding
capacity, but instead it increases wear on the machine and the sanding sheet.
• Use only the tip or an edge of the sanding sheet for precise sanding of edges,
corners and hard to reach areas.
• When selectively sanding on one spot, the sanding sheet can heat up considerably.
Remove the tool from the surface periodically to permit the sanding sheet to cool
down.
• A sanding sheet that has been used for metal should not be used for other
materials.
• Use only original sanding accessories. For sanding, always connect dust
extraction.
b. Scraping
The tool is suitable for scrapping and removing surface coverings. For scraping, select
a high speed setting.
• To remove surface covers, place the scraping blade vertically on the work-piece
• Switch the tool on and cut down through the covering.
• Place the tool at a flat angle (not over 20°) and apply alight forward pressure to
remove the covering.
c. Cutting
Saw blades are ideal for making precise cuts in tight areas, close to edges or flush to a
•
Hold the tool firmly to control the
twisting of the tool.
•
To prolong the life of the tool never
overload it.
•
To turn the tool ON, push the on/off
switch forward. To turn it OFF, push
the switch backward.
76 | 77
GB
Publicité
