Publicité
Les langues disponibles
Les langues disponibles
NOTE: Attach the application tool at the desired orientation for the task at hand. The
shaft is configured so that the application tool can be attached every 30°around the
shaft, from 0°to 330° (Fig. 2)
Fig. 2
!
During use we do not recommend to attach the application tool
facing backwards, as operation in this position may cause serious
injury. (Fig. 3)
WARNUNG
Fig. 3
b. Mounting/changing the sandpaper (Fig. 4)
Fig.
4
1. Follow the directions for attaching
the application tool to attach the
sanding plate to the multi tool.
2. Align the sandpaper with the sanding
plate and use your hand to press it
firmly on the sanding plate.
3. Press the sandpaper firmly against
a smooth surface for a short period,
and then switch on the tool. The burr
will form a non-slip bond with the
outer edge of the sandpaper felt.
This will avoid premature wear.
If one point has become worn, pull off the
sandpaper, turn it 120° and place it on
again.
74 | 75
GB
Publicité
