Pontec PondoTronic UVC 7/11 Notice D'emploi page 10

- EN -
Product description
Scope of delivery
 A
1 Casing
2 Unit head with UVC lamp
3
∅ 19 ... 38 mm (0.75 ... 1.5 inch) stepped hose adapter with O-ring
4 Operating instructions
Function description
The special UVC radiation of the UVC clarifier eliminates floating algae and other algae that give water a green color. It
also kills bacteria and other germs. The UVC clarifier is integrated in the water circuit, ideally upstream of a filter.
Intended use
Only use the product described in this manual as follows:
• For cleaning garden ponds.
• For operation with clean water.
• Operate the product in compliance with the technical data. (→ Technical data)
The following restrictions apply to the unit:
• This product is not suitable for general lighting, but is only intended for the purpose described here.
• The UVC clarifier installed in the device kills algae and bacteria in the pond water. The UVC lamp may never be
used for any other purpose or outside of the casing.
• Do not use for commercial or industrial purposes.
• Never use the unit with fluids other than water.
• Not to be used for sterilizing drinking water or other fluids.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
Prerequisite
• The unit head is removed. (→ Dismantling the unit head)
Installing the unit
How to proceed:
 B, C
• Install the unit at least 2 m (6.5 ft) from the edge of the pond.
• Only install the unit in the permitted positions to ensure fault-free operation.
• Allow sufficient space for carrying out maintenance work.
• Reinstall the unit head after screwing the casing to the ground. (→ Fitting the unit head)
Establishing the connections
How to proceed:
 D
1. Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
2. Slip the hose clip over the hose, fit the hose onto the hose connector and secure it with the hose clip.
– In the case of a stepped hose adapter with a separate union nut, first push the union nut over the hose.
3. Connect the stepped hose adapter with seal to the casing.
– Connect the inlet and outlet.
– Hand tighten the stepped hose adapter.
10