Whirlpool 819041994 Guide D'utilisation page 11

To set Timer to turn on air conditioner, keeping previous
settings:
1. Turn off air conditioner.
2. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before air conditioner will turn off.
3. Press the plus or minus button to change delay time (0.5 to
24 hours).
4. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on.
To set the Timer delay for a 0.5- to 24-hour delay until the
air conditioner turns on, changing the previous settings:
1. Turn on air conditioner.
2. Adjust Mode to Cool, Heat (on some models), Fan Only, or
Power Saver.
3. Adjust Fan Speed to Auto, Turbo, High or Low.
4. Adjust temperature between 66°F (19ºC) and 88°F (31ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before air conditioner will turn on.
7. Press the plus or minus button to change delay time (0.5 to
24 hours).
8. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show current room temperature.
To operate air conditioner with remote control
NOTE: Remote control may vary in appearance.
NOTE: Two AA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To turn the air conditioner on or off:
Press POWER.
To select the mode:
1. Press MODE to choose Cool, Heat (on some models) or Fan
Only.
2. Press POWER SAVER to choose Power Saver mode.
Cool, Heat (on some models), Fan Only or Power Saver—
you can adjust the fan speed.
To select the fan speed:
Press AUTO, TURBO, HIGH or LOW.
To raise the temperature:
Press the plus button. Display on air conditioner shows the
Temperature control setting. Each time you press or hold the plus
button, the temperature will increase 1º until it reaches 88°F
(31ºC).
NOTE: After 3 seconds, display on air conditioner will show the
set room temperature.
To lower the temperature:
Press the minus button. Display on air conditioner shows the
Temperature control setting. Each time you press or hold the
minus button, the temperature will decrease 1º until it reaches
66°F (19ºC).
NOTE: After 3 seconds, display on air conditioner will show the
set room temperature.
11