Publicité
_ ALL OPERATING AND ASSEMBLY
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
_ DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITH STAND LOADS.
_ ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.
_ CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS
BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED
FLAME.
_ WARNING:
LEG OPENINGS AND STRANGLE,
NEVER USE IN RECLINE CARRIAGE
POSITION UNLESS FOOTREST
ENCLOSURE IS FULLY INSTALLED/
IMPLEMENTED (SEE MANUAL
INSTRUCTIONS FOR CORRECT USE).
_ WARNING:
MATTRESS PAD.
NOTICE
THIS ARTICLE MEETS OR EXCEEDS ALL
REQUIREMENTS COVERED IN ASTM F833
STANDARD AND LATEST REVISIONS.
COMPONENTS OF THE ITEM
Check the contents of the packaging and if
you have any complaints please contact the
Assistance Service.
_ Pliko Four: a basket, 2 swiveling or locking front
wheels, 2 rear wheels, cup holder, front bar,
hood.
INSTRUCTIONS FOR USE
1• OPENING: pull the two levers on the handlebars
upwards (Fig. a), lift the chassis and it will
open automatically. To make sure that the
stroller is correctly open, check the two side
hooks (Fig. b).
CHILD MAY SLIP INTO
DO NOT ADD A
If the straps are not fasten correctly, press
onto the seat (fig_c) until it clicks into place.
2• BASKET: to mount the basket, slip the loops
over the front hooks A and rear hooks B and
C. The figure shows the attached basket.
3• CUP HOLDER :It can be applied on the 4
knobs on the chassis. Two are on the left or
right side of the handle and two on the sides
of the pushchair's chassis, at the height of the
bumper, on the right or left . To apply the cup
holder, attach it and press until it clicks into
place (Fig. a)
ADJUSTING THE HANDLEBARS: The height
of the 3 handlebars can be adjusted to two
positions. For the higher position, press the
button while pulling the handlebars upwards.
To lower it, do the opposite (Fig.b).
4• BRAKE: to set the brakes on the stroller, lower
the levers on the rear wheels with your foot
(Fig.a). To release the brakes, lift the lever.
Always set the brakes when the stroller is
not moving.
SWIVEL WHEELS: to swivel the front wheels
lower the levers as shown in arrow 1 (Fig.b).
WHEELS IN STATIONARY POSITION: To
make them stationary, push the lever in the
opposite direction, as indicated by arrow 2.
5• HOOD: to mount the hood, fasten the
attachments which are situated on the
sides of the hood onto those on the chassis,
pushing outwards until the hood clicks into
place (Fig.a); fasten it onto the inside of the
armrest (Fig.b),
6 •and onto the backrest of the stroller (Fig.c).
The hood has a window enabling you to
observe your child, a large and practical
pocket (Fig.d) and a cord which games can
be hung on (Fig.e).
To remove the hood: unhook the hood's
side attachments from the chassis by pulling
inwards, unbutton it from the inside of the
armrest and from the backrest of the stroller.
7 •You can detach the back part of the fabric by
unzipping it and use the hood also as a sun
canopy (Fig.a). To reattach the back part of the
fabric, close the zipper (Fig.b).
8 •By lowering the stroller backrest, the rear
hood extends and through the double zipper
a window can be created to allow more air to
circulate and watch the child when sleeping.
9 •5-POINT SAFETY HARNESS: to fasten, insert
the two buckles of the waist strap (with
attached shoulder straps, arrow a) into the leg
divider strap until they click into place (arrow
b). To unfasten them, press the button which
is situated in the centre of the fastener (arrow
c) and pull the waist strap outwards (arrow d).
- 13 -
Publicité
