AEG Electrolux CS 5 Série Mode D'emploi page 33

822_949_352 CS5200.book Seite 33 Mittwoch, 9. Mai 2007 7:26 19
Then let the water flow out into the
drip tray underneath, or alternatively
use this water to fill (and then empty)
the cup to be used for the coffee, so as
to pre-heat it.
3) Unless preheated, do not use cups
that are too thick, as they will absorb
too much heat.
4) Use cups that have been previously
heated by rinsing them with hot water
or alternatively by leaving them for at
least 20 minutes on the cup warmer
tray on top of the machine with the
appliance on.
Note 4: while the machine is making
3
the coffee, the delivery can be stopped
at any time by pressing the
(Fig. 13) or
turning the coffee quantity selector
knob (Fig. 10) anti-clockwise.
Note 5: as soon as delivery is complete,
3
to increase the quantity of coffee, sim-
ply press and hold the
13) or button (Fig. 14), until
reaching the desired quantity, or turn
the coffee quantity selector knob (Fig.
10) clockwise (this operation must be
performed immediately after the cof-
fee is dispensed and before the coffee
grounds are ejected into the grounds
container).
Note 6: when the
3
the water tank must be filled, other-
wise the coffee cannot be made. The
water tank can only be removed if the
milk frother is first positioned towards
the centre of the machine. (It is normal
for there to be a little water left in the
tank when the alarm comes on).
Note 7: the machine counts the
3
number of cups of coffee made. Each
14 single cups (or 7 double cups), the
light switches on steady, warning
the user that the grounds container is
full and must be emptied and cleaned,
see 9.2 „Emptying the grounds
container", page 36.
button
button (Fig. 14), or by
button (Fig.
alarm comes on,
Note 8: the grinder in the coffee
3
maker may become worn over time
and consequently the coffee will
change taste as it is ground more
coarsely.
To resolve this problem, re-set the
grinding coarseness on the coffee
grinder by adjusting the knob (Fig. 17)
one click anticlockwise (as described in
section 5 „Adjusting the coffee
grinder", page 34).
Note 9: if the machine is not used for a
3
long period, the infuser must be
cleaned, as described in section 9.3
„Cleaning the infuser", page 37.
3 Note 10: while the machine is deliver-
ing coffee, never remove the water
tank. If it is removed, the machine will
not be able to make the coffee and the
"no water" light will flash. If you
try and make another coffee, the
machine becomes noisy and does not
make the coffee. To reset the machine,
turn the steam knob anticlockwise as
far as it will go and run off water from
the milk frother for a few seconds.
3 When using the machine for the first
time, 4-5 cups of coffee made before
the machine starts to give satisfying
results.
When an alarm light comes on to sig-
3
nal an anomaly, do not contact the
service centre straight away. The prob-
lems can almost always be resolved by
following the instructions indicated in
section 11 „Meaning of the alarm indi-
cator lights and what to do when they
are on", page 39 and section 12 „Prob-
lems that can be resolved before call-
ing the Customer Service Centre",
page 41. If necessary, contact the Cus-
tomer Service Centre.
g
33