Areas Of Application; Injector Modules; Inserting An Injector Module; Removing An Injector Module - Miele professional A 306 Mode D'emploi

en - Areas of application
Inserting an
injector module
Removing an
injector module
24

Injector modules

 Only place empty, unloaded modules in baskets. Check that
they are correctly engaged before loading them.
Modules must be completely emptied before taking them out.
Placing loaded modules in baskets or removing them can cause
damage to the wash load and cause injury should glassware be
broken.
This injector module is only suitable for use in lower basket A 150.
The injector nozzles must point upwards.
Carefully slide the injector module in and connect it to the water

connection point.
Then press down on the module to secure it on the rails in the bas‐

ket.
Do not attempt to pull the basket out of the washer-disinfector by
the injector module.
The module could come loose or the water connection point could
suffer damage.
Release the module from its position, then carefully pull it off the

water connection point. Do not pull it off at too steep an angle as
any levering action could damage both the connection point and
the coupling.